Arrange all the skirt layers. Begin with the outer layer, then insert the tulle, then the lining.
Pin together around he waistline.
Stitch together within the seam allowance.
Lay the ZIP OPENING BINDING piece along the line shown on the skirt pattern.
Pin and stitch around the line as shown on the pattern pieces through all layers of the skirt.
Ensure to line up the the BACK BODICE centre back seam allowance with the new ZIP BINDING piece inserted into the skirt.
Stitch the seam allowance.
Finish the seam allowance with an overlocker or zig-zag stitch. Подстригване, ако е необходимо.
ADVANCED TIP: Use bias binding to conceal the waistline seam allowance.
Обърнете дрехата на дясната страна на вън.
Using the zip foot and starting from the right side, top stitch through the garment, zip tape and seam allowance the full length of the zip, backstitching over the end before completing up to the top again.
Using small scissors, carefully open up the machine basting stitches down the centre back.
Finish the hems for the lining and outer SKIRT either by adding a trim, creating a rolled hem, or using an edge stitch on an overlocker.
Below shows how to add a lace trim:
Apply the trim as you sew, leaving approx. 1cm unstitched to allow to fold. Complete the trim edge by folding the ends of the trim as shown and stitch in place to secure the loop.
Шева с зиг-заг.
Сгънете тапицерия за WS и най-бод с зиг-заг бод да се осигури.
To complete the TIE lay both pieces RIGHT SIDES together.
Pin then stitch the seam allowance all the way round leaving an unstitched gap of about 10cm.
Clip and trim the seam allowance.
Turn the TIE RIGHT SIDES out. Fold the seam allowance of the opening inside and press the whole TIE flat.
Top stitch close to the edge all the way round to secure the opening and strengthen the TIE.