STAP 1:
Suitable for fleece/jersey/towelling fabric
Turn the SLEEVE cuff back 1.5cm to the RIGHT SIDE, LEES DIE DRUKINSTRUKSIES VOORDAT DU DRUK WWW.THE-TAILORESS.COM/PRINTING-INSTRUCTIONS 1.5cm naattoelating ingesluit Geskik vir fleece/jersey/handdoekstof Draai die MOU-manchet 1.5cm terug na die REGTERKANT.
Top stitch close to the edge on the RIGHT SIDE.
STAP 2:
Match the back SLEEVE armhole with the BACK, Regte kante teen mekaar.
Pin en steek. Finish with either an overlocker or zig-zag stitch. Sny die naattoelating.
STAP 3:
Match the FRONT armhole with the front SLEEVE, Regte kante teen mekaar.
Speld, steek en eindig soos voorheen.
Herhaal stappe 1-2 vir die ander mou.
STAP 4:
Lê die FRONT regte kante teen mekaar met die agterkant, matching the side seam and SLEEVE seam allowances.
Speld, steek en eindig.
Clip almost up to the seam allowance at the underarm point to allow the garment to lay flat once turned. If you have finished the seam allowance close to the body this may not be necessary
STAP 5:
Finish the garment hemline using your preferred finishing method.
Turn the hemline towards the WRONG SIDE 1.5cm.
Topstitch to secure.
STAP 6:
Fold the length of the COLLAR in half RIGHT SIDES together.
Pin and stitch the two shorter ends. Clip the corners and trim down to 5mm.
Draai regte kante uit.
STAP 7:
Match the raw edges of the COLLAR around the garment opening.
Speld, steek en eindig.
Top stitch close to the seam from the RIGHT SIDE to secure the seam allowance flat.
STAP 8:
Lay the two WAISTBAND pieces RIGHT SIDES together.
Pin and stitch all around leaving a gap of approximately 10cm to turn right sides out.
Turn RIGHT SIDES out and press seams flat. Top stitch around the edges to hold flat and seal the 10cm opening.
Apply a piece of velcro to either side of the WAISTBAND at the ends, approximately 5cm long.
STAP 9:
Align the WAISTBAND with the underarm points.
Top stitch through the WAISTBAND and BACK to secure in place.