TRIN 1:
Suitable for fleece/jersey/towelling fabric
Turn the SLEEVE cuff back 1.5cm to the RIGHT SIDE, fold den derefter igen på sig selv 3 cm.
Top stitch close to the edge on the RIGHT SIDE.
TRIN 2:
Match the back SLEEVE armhole with the BACK, Ret mod ret.
Pin og søm. Finish with either an overlocker or zig-zag stitch. Trim sømrummet.
TRIN 3:
Match the FRONT armhole with the front SLEEVE, Ret mod ret.
Pin, søm og slutte som før.
Gentag trin 1-2 for det andet ærmegab.
TRIN 4:
Læg den forreste højre SIDER sammen med TILBAGE, matching the side seam and SLEEVE seam allowances.
Pin, søm og finish.
Klip næsten op til sømrummet ved punktet under armene, så tøjet kan ligge fladt, når det først er vendt. Hvis du er færdig med sømrummet tæt på kroppen, er dette muligvis ikke nødvendigt
TRIN 5:
Finish the garment hemline using your preferred finishing method.
Turn the hemline towards the WRONG SIDE 1.5cm.
Topstitch to secure.
TRIN 6:
Fold the length of the COLLAR in half RIGHT SIDES together.
Pin and stitch the two shorter ends. Clip the corners and trim down to 5mm.
Drej til højre SIDER ud.
TRIN 7:
Match the raw edges of the COLLAR around the garment opening.
Pin, søm og finish.
Top stitch close to the seam from the RIGHT SIDE to secure the seam allowance flat.
TRIN 8:
Lay the two WAISTBAND pieces RIGHT SIDES together.
Pin and stitch all around leaving a gap of approximately 10cm to turn right sides out.
Turn RIGHT SIDES out and press seams flat. Top stitch around the edges to hold flat and seal the 10cm opening.
Apply a piece of velcro to either side of the WAISTBAND at the ends, approximately 5cm long.
TRIN 9:
Align the WAISTBAND with the underarm points.
Top stitch through the WAISTBAND and BACK to secure in place.