Taschentuch Top Tutorial

SCHRITT 1:

Damit dieses Muster funktioniert, können Sie eine beliebige Länge und Breite des Stoffes verwenden, sofern dieser nicht weniger als 1 mx 1 m beträgt. Die Verwendung größerer Mengen führt zu einem längeren Oberteil oder Kleid.

Begin by finishing the lower edges of the FACING pieces and the edges of the main square of fabric (if it isn’t already finished), using a rolled hem or overlocking stitch.

SCHRITT 2:

Lay the two FACING pieces RIGHT SIDES together and pin and stitch the side seams.

SCHRITT 3:

Decide on which way you’d like the corners of the ‘handkerchief’ to fall. Cutting it open along the the straight of grain will have all the corners draping at the sides of the garment. Cutting it along the bias will have the corners hanging at the centre front and back and sides.

SCHRITT 4:

Mark the ARMHOLE and NECKLINE points.

Nehmen Sie Ihr Stück Stoff und in der Mitte falten, dann in der Hälfte wieder, creating either a square or triangle. Markieren Sie die korrekte Messung des Oberflächenmaterials auf den Falten. Measurements shown represent distance from centre point.

Cut across the fabric from the centre point to the ARMHOLE and NECKLINE points, opening up the centre of the fabric.

SCHRITT 5:

Open up the cuts and lay the fabric out with the front and back necklines together.

Match the FACING with the necklines RIGHT SIDES TOGETHER, the side seams match with the low points of the underarm cuts. Insert the STRAPS to the front and back points, between the FACING and the handkerchief. Make sure to have the STRAPS RIGHT SIDES together with the handkerchief.

SCHRITT 6:

Pin und Stich.

When approaching the inward corners, sew down to the point, put the needle down then turn your work and ensure the fabric is flat without any wrinkles before continuing to sew.

Back stitch over the STRAP insertions to properly secure.

SCHRITT 7:

Clip the inward points almost to the stitch line, and trim the outer point to reduce bulk.

Drehen Sie das Kleidungsstück der rechten Seite aus.

Gently press along the facing edge to set the seam.