This is a lined bra and requires inner and outer pieces to be cut.
לגזור את כל החלקים. Mark the STRAP INSERTION POINTS on the BAND and the areas to leave unstitched as indicated on the pattern by the dashed lines at the center front (CF) and around the FRONT STRAP INSERTION point.
Match the side seams of the BAND and CUP sections RIGHT SIDES together.
פִּין, straight stitch and finish with an overlocker or zig zag stitch.
Lay the inner and outer bra pieces RIGHT SIDES together.
Cut two 10cm lengths of cord and loop though the bra rings. Fold in half and insert between the inner and outer fabric at the STRAP INSERTION POINT on the BAND.
For support at the CF pin a length of bias binding or non-stretch tape (max. width 1.5cm) up to the CF seam allowance of the inner fabric.
Cut four squares of garment fabric and place over the STRAP INSERTION POINTS on the CUP. Sandwich each INSERTION POINT between two pieces.
Stitch the seam allowance using zig-zag stitch as shown, leaving open the areas marked by dashed lines.
Backstitch over the inserted straps on the BAND for extra strength.
חתוך את קצבאות התפר.
Turn the garment RIGHT SIDES OUT via the CF opening.
Fold the CF seam allowance to the inside. לחץ כל התפרים.
Top stitch using zig-zag stitch approx. 1cm from the edge leaving open the CUP STRAP INSERTION POINT and the CF. This time do stitch over the BAND STRAP INSERTION POINT.
This will create the channel to insert the tie cords.
Cut 2.5m of cord. Ideally using a seam turner or other tool such as a crochet hook, feed the cord though the channels of the upper seam of the bra.
Begin by inserting the hook into the CF and out of the first CUP STRAP INSERTION POINT.
Attach the cord to the hook and pull though to the CF.
Loop the other end of the cord first through the bra slider then through the first bra ring.
Pass the cord back through the bra slider to complete the strap.
Insert the hook into the second STRAP INSERTION POINT on the BAND and out through the first INSERTION POINT.
Attach the cord to the hook again then pull through the second STRAP INSERTION POINT on the BAND.
Loop through the second bra slider and bra ring and back through the slider.
Insert the hook into the second CF and out through the second STRAP INSERTION POINT on the CUP.
Attach the cord again and pull though the CF.