ステップ 1:
Suitable for fleece/jersey/towelling fabric
Turn the SLEEVE cuff back 1.5cm to the RIGHT SIDE, then fold it again back on itself 3cm.
Top stitch close to the edge on the RIGHT SIDE.
ステップ 2:
Match the back SLEEVE armhole with the BACK, 一緒に右側.
ピンとステッチ. Finish with either an overlocker or zig-zag stitch. 縫い代をトリム.
ステップ 3:
Match the FRONT armhole with the front SLEEVE, 一緒に右側.
ピン, ステッチ前と同じように仕上げ.
繰り返し手順 1-2 他のアームホールのための.
ステップ 4:
前面と背面を一緒に配置します, matching the side seam and SLEEVE seam allowances.
ピン, ステッチと仕上げ.
脇の下の縫い代近くまでクリップを留めて、裏返したときに衣服が平らになるようにします。. 身頃近くの縫い代が終わっている場合は必要ない場合があります。
ステップ 5:
Finish the garment hemline using your preferred finishing method.
Turn the hemline towards the WRONG SIDE 1.5cm.
Topstitch to secure.
ステップ 6:
Fold the length of the COLLAR in half RIGHT SIDES together.
Pin and stitch the two shorter ends. Clip the corners and trim down to 5mm.
右側を回し.
ステップ 7:
Match the raw edges of the COLLAR around the garment opening.
ピン, ステッチと仕上げ.
Top stitch close to the seam from the RIGHT SIDE to secure the seam allowance flat.
ステップ 8:
Lay the two WAISTBAND pieces RIGHT SIDES together.
Pin and stitch all around leaving a gap of approximately 10cm to turn right sides out.
Turn RIGHT SIDES out and press seams flat. Top stitch around the edges to hold flat and seal the 10cm opening.
Apply a piece of velcro to either side of the WAISTBAND at the ends, approximately 5cm long.
ステップ 9:
Align the WAISTBAND with the underarm points.
Top stitch through the WAISTBAND and BACK to secure in place.