Joey Tee Tutorial
[printfriendly]
Attēli ir pieejami modelis lejupielāde.
[wc_accordion collapse=”0″ leaveopen=”0″ klase=”” layout=”box”]
[wc_accordion_section title=”Step 1″]
Cut out all pieces marking any balance or ease marks. This garment will have reasonable stretch to it so it is recommended to use zig-zag stitch wherever a seam is constructed.
Lay the front edge of the SLEEVE armhole to the FRONT armhole, Labās puses kopā.
Pin un valdziņu šuvi pabalstu.
Repeat for the other FRONT side.
[/wc_accordion_section]
[wc_accordion_section title=”Step 2″]
Lay the back SLEEVE armhole to the BACK armhole RIGHT SIDES together.
Pin un valdziņu šuvi pabalstu.
Repeat for the other BACK side.
Finish all sleeve seam allowances using an overlocker or zig-zag stitch. Trim ja nepieciešams.
[/wc_accordion_section]
[wc_accordion_section title=”Step 3″]
Ar apģērba nepareizu pusēm pārklāts out, align the side seams and SLEEVE seams.
Pin and stitch continuously from SLEEVE cuff to the garment hem.
Finish the seam allowances as before.
[/wc_accordion_section]
[wc_accordion_section title=”Step 4″]
BEZ HOOD:
Reizes pusi kakla stulmmalās labās puses kopā un sew īso šuvi pabalstu.
Reizes kakla aproci pusē tā, ka izejvielas malas satikt.
Vienkārša ap apģērba kakla izgriezuma. Pin un dūrienu vietā.
For HOOD see Steps 5-7.
[/wc_accordion_section]
[wc_accordion_section title=”Step 5″]
ar kapuci:
Izklāt divas Hood gabalus labajā pusē kopā. Pin un valdziņu centrā atpakaļ šuve pabalstu. Trim un pabeigt šuves pabalstu ar zig-zag dūrienu vai overlocking dūrienu.
[/wc_accordion_section]
[wc_accordion_section title=”Step 6″]
Complete the hood by folding the front opening seam allowance back 0.75mm then again 0.75mm. Pin un dūrienu vietā, lai pabeigtu šuvi.
[/wc_accordion_section]
[wc_accordion_section title=”Step 7″]
Ease the neckline of the HOOD on to the garment neckline. Overlap the centre front edges of the HOOD by 1.5cm onto each other.
Pin un valdziņš. Finish šuvi pabalstu.
You may like to top-stitch the seam allowance flat towards the bottom of the garment.
[/wc_accordion_section]
[wc_accordion_section title=”Step 8″]
Pabeigt apģērba vīli un aproces ar apdari šuves pabalstu, tad locīšanas atpakaļ 1,5 cm un top-brošēšana, lai nodrošinātu.
Nospiediet visas šuves.
[/wc_accordion_section]
[/wc_accordion]