STEP 1:
Suitable for fleece/jersey/towelling fabric
Turn the SLEEVE cuff back 1.5cm to the RIGHT SIDE, kemudian lipat semula pada 3cm.
Top stitch close to the edge on the RIGHT SIDE.
STEP 2:
Match the back SLEEVE armhole with the BACK, BELAH KANAN bersama-sama.
Pin dan stitch. Finish with either an overlocker or zig-zag stitch. Mengurangkan elaun jahitan.
STEP 3:
Match the FRONT armhole with the front SLEEVE, BELAH KANAN bersama-sama.
pin, menjahit dan menyelesaikan seperti sebelum ini.
Langkah-langkah berulang 1-2 for the other armhole.
STEP 4:
Meletakkan FRONT RIGHT BELAH bersama-sama dengan BACK, matching the side seam and SLEEVE seam allowances.
pin, menjahit dan menyelesaikan.
Clip almost up to the seam allowance at the underarm point to allow the garment to lay flat once turned. If you have finished the seam allowance close to the body this may not be necessary
STEP 5:
Finish the garment hemline using your preferred finishing method.
Turn the hemline towards the WRONG SIDE 1.5cm.
Topstitch to secure.
STEP 6:
Fold the length of the COLLAR in half RIGHT SIDES together.
Pin and stitch the two shorter ends. Clip the corners and trim down to 5mm.
Pusingan BELAH KANAN keluar.
STEP 7:
Match the raw edges of the COLLAR around the garment opening.
pin, menjahit dan menyelesaikan.
Top stitch close to the seam from the RIGHT SIDE to secure the seam allowance flat.
STEP 8:
Lay the two WAISTBAND pieces RIGHT SIDES together.
Pin and stitch all around leaving a gap of approximately 10cm to turn right sides out.
Turn RIGHT SIDES out and press seams flat. Top stitch around the edges to hold flat and seal the 10cm opening.
Apply a piece of velcro to either side of the WAISTBAND at the ends, approximately 5cm long.
STEP 9:
Align the WAISTBAND with the underarm points.
Top stitch through the WAISTBAND and BACK to secure in place.