Tutorial Gerda Kimono

 

STEP 1:

Sila baca arahan percetakan!

Buat poket welt pada kepingan DEPAN. Ikuti tutorial welt pocket yang disertakan atau cari di sini: https://www.the-tailoress.com/product/welt-pockets-pdf-sewing-pattern/

 

STEP 2:

Dengan HUBUNGAN BELAH SALAH sehingga, lipat belakang 1cm satu hujung. Lipat belakang 5mm bersama-sama kedua-dua pihak panjang dan tekan. Kemudian lipat TIE pada separuh menyembunyikan tepi mentah sebelum bertukar dalam. Stitch in place.

Satu hujung akan kekal sebagai kelebihan mentah, ini akan dijahit ke dalam jahitan tepi pakaian.

STEP 3:

Lipat kolar KANAN BELAH bersama-sama memanjang. Menjahit elaun jahitan bawah bersama-sama. Klip sudut dan mengurangkan elaun jahitan. Pusingan BELAH KANAN keluar dan tekan.

STEP 4:

Meletakkan FRONT dan BACK RIGHT BELAH bersama-sama. Pin dan menjahit elaun bahu jahitan.

Ulang untuk bahagian lain.

STEP 5:

Lay the SLEEVE RIGHT SIDES together with the FRONT and BACK pieces. Matching the underarm points.

Pin and stitch the seam allowance between the underarm points.

Tekan jahitan terbuka. Repeat for the other SLEEVE.

STEP 6:

Dengan pakaian BELAH SALAH keluar, match the SLEEVE seam allowances and the side seams of the FRONT and BACK.

Insert the TIE at the tie insertion point of the side seam on one side. Insert it between the FRONT and BACK so that it is visible on the RIGHT SIDE of the garment once sewn.

Pin and stitch the SLEEVE from the underarm point at the sleeve opening, around the curve to the lowest inside point of the SLEEVE. Finish the seam allowances by clipping the curved edge and trimming to 7mm.

Pin and stitch the side seam from the underarm point to the hemline. Turn RIGHT SIDES out and press the seams allowances.

STEP 7:

With the RIGHT SIDES out, pin the COLLAR around the centre front and neckline of the FRONT and BACK.

Pin the remaining TIE at the tie insertion point on the opposite side to where the side seam TIE is placed, on the centre FRONT.

Stitch just within the seam allowance.

STEP 8:

Follow Steps 4-6 to create the lining, ignoring references to the TIES and there’s no need to clip the SLEEVE seam allowance.

STEP 9:

Arrange the lining RIGHT SIDES together with the main garment. Pin and stitch around the centre front opening, including the COLLAR.

Stitch in place.

Pusingan BELAH KANAN keluar dan tekan.

STEP 10:

Turn back the seam allowances of the SLEEVE at both openings. Secure with small hand stitches. akhbar.

Turn up the main garment hemline 1 inch / 2.5cms and press. Turn up the lining hemline the same amount and pin. Sew together using hem stitch.