PASS 1:
Suitable for fleece/jersey/towelling fabric
Turn the SLEEVE cuff back 1.5cm to the RIGHT SIDE, then fold it again back on itself 3cm.
Top stitch close to the edge on the RIGHT SIDE.
PASS 2:
Match the back SLEEVE armhole with the BACK, Ġnub tal-lemin flimkien.
Pin u stitch. Finish with either an overlocker or zig-zag stitch. Trim the seam allowance.
PASS 3:
Match the FRONT armhole with the front SLEEVE, Ġnub tal-lemin flimkien.
Pin, stitch and finish as before.
Repeat Steps 1-2 for the other armhole.
PASS 4:
Qiegħed il-Ġnub tal-Lemin ta’ QUDDIEM flimkien mad-DAĦAR, matching the side seam and SLEEVE seam allowances.
Pin, stitch and finish.
Iklip kważi sal-konċessjoni tal-ħjata fil-punt ta 'taħt id-driegħ biex tippermetti li l-ilbies ikun ċatt ladarba ddawwar. Jekk spiċċajt il-konċessjoni tal-ħjata qrib il-ġisem dan jista' ma jkunx meħtieġ
PASS 5:
Finish the garment hemline using your preferred finishing method.
Turn the hemline towards the WRONG SIDE 1.5cm.
Topstitch to secure.
PASS 6:
Fold the length of the COLLAR in half RIGHT SIDES together.
Pin and stitch the two shorter ends. Clip the corners and trim down to 5mm.
Dawwar in-naħat tal-lemin barra.
PASS 7:
Match the raw edges of the COLLAR around the garment opening.
Pin, stitch and finish.
Top stitch close to the seam from the RIGHT SIDE to secure the seam allowance flat.
PASS 8:
Lay the two WAISTBAND pieces RIGHT SIDES together.
Pin and stitch all around leaving a gap of approximately 10cm to turn right sides out.
Turn RIGHT SIDES out and press seams flat. Top stitch around the edges to hold flat and seal the 10cm opening.
Apply a piece of velcro to either side of the WAISTBAND at the ends, approximately 5cm long.
PASS 9:
Align the WAISTBAND with the underarm points.
Top stitch through the WAISTBAND and BACK to secure in place.