Lommetørkle Toppopplæring


For at dette mønsteret skal fungere kan du bruke hvilken som helst lengde og bredde på stoffet så lenge det ikke er mindre enn 1m x 1m. Bruk av større mengder vil resultere i en lengre topp eller kjole.

Begin by finishing the lower edges of the FACING pieces and the edges of the main square of fabric (if it isn’t already finished), using a rolled hem or overlocking stitch.


Lay the two FACING pieces RIGHT SIDES together and pin and stitch the side seams.


Decide on which way you’d like the corners of the ‘handkerchief’ to fall. Cutting it open along the the straight of grain will have all the corners draping at the sides of the garment. Cutting it along the bias will have the corners hanging at the centre front and back and sides.


Mark the ARMHOLE and NECKLINE points.

Ta din del av stoff og brett i to, deretter i to igjen, creating either a square or triangle. Marker riktig måling for vender på foldene. Measurements shown represent distance from centre point.

Cut across the fabric from the centre point to the ARMHOLE and NECKLINE points, opening up the centre of the fabric.


Open up the cuts and lay the fabric out with the front and back necklines together.

Match the FACING with the necklines RIGHT SIDES TOGETHER, the side seams match with the low points of the underarm cuts. Insert the STRAPS to the front and back points, between the FACING and the handkerchief. Make sure to have the STRAPS RIGHT SIDES together with the handkerchief.


Pin og sting.

When approaching the inward corners, sew down to the point, put the needle down then turn your work and ensure the fabric is flat without any wrinkles before continuing to sew.

Back stitch over the STRAP insertions to properly secure.


Clip the inward points almost to the stitch line, and trim the outer point to reduce bulk.

Snu plagget høyre side ut.

Gently press along the facing edge to set the seam.