බාබරා Monokini PDF මැහුම් රටාව

Place the TOP FRONT lining and outer pieces RIGHT SIDES together.

Pin elastic along the lines shown in the image.

Ensure to leave a 1.5cm gap along the neckline and at the TIE CHANNEL points marked on the pattern. This is to allow the Ties to be threaded through.

Zig zag stitch භාවිතා stitch. නම්ය ඉල්ලුමක් ඇති සමීප වේග දීමනාවක් සිඳීම.

Turn to the RIGHT SIDE, tuck the seam allowances from the TIE CHANNELS to the inside. Secure using small hand stitches.

ඉඟිය: Use a ballpoint needle for stretch fabrics to save a lot of problems with stitch formation!

ඉඟිය: Use a ballpoint needle for stretch fabrics to save a lot of problems with stitch formation!

Lay the inner and outer Front pieces RIGHT SIDES together.

Pin elastic along the lines shown in the image.

Zig zag stitch භාවිතා stitch. Trim seam.

නැවත පියවර 2 for the inner and outer BACK pieces.

Fold the WAISTBAND in half RIGHT SIDES together and straight stitch along the CENTER BACK seam allowance to form the WAISTBAND.

Repeat for the inner WAISTBAND piece.

With the TOP FRONT RIGHT SIDES out, use the largest stitch on your sewing machine or a hand stitch to run a row along the lower edge (through both inner and outer pieces).Do not secure either end with a backstitch or knot.

Secure one end of the thread using a figure of eight around a pin then gently gather the rest until it measures one halt the top measurement of the FRONT bikini bottom, less 2cm.

එකට දකුණු පසින් සමග, pin the gathered edge of the TOP FRONT to the top edge of the WAISTBAND. Start by matching the TOP FRONT CENTER FRONT to 2cm away from the CENTER FRONT on the waistband.

Repeat for the other TOP FRONT.

Straight stitch both TOP FRONT pieces in place 0.75cm into the seam allowance.

Place the inner WAISTBAND RIGHT SIDES together with the inner TOP FRONT sections. Pin all the way around encasing the TOP FRONT pieces and forming the top seam allowance of the WAISTBAND. Stitch the seam with elastic using zig zag stitch.

To connect the FRONT and BACK pieces, open up the Left side seam of the FRONT and place RIGHT SIDES together with the corresponding open side seams of the BACK. Pin and straight stitch across. අනෙක් පැත්තේ සඳහා නැවත නැවත.

Clip seam intersections and trim the seam allowances.

The two pieces should now be connected but allow you to open the top hip area.

Place the SKIRT pieces RIGHT SIDES together.

Straight stitch along the lines shown. Trim seam. Turn RIGHT SIDES out.

Turn the SKIRT RIGHT SIDES out. Top stitch using zig-zag close to the seam line to preserve the integrity of the edge.

Match CENTER FRONT points of lower WAISTBAND and SKIRT. Pin Skirt RIGHT SIDES together with WAISTBAND. Stitch using Zig Zag 0.75cm into seam allowance. You may like to continue this line of stitches all around to keep the WAISTBAND together ready for the next step.

Turn RIGHT SIDES out.

Turn TOP FRONT with WAISTBAND and Skirt WRONG SIDES out. Place RIGHT SIDES together and around the bottoms. Pin and stitch the RIGHT SIDE top garment to the bottoms; leave the WRONG SIDE part of the garment unattached to the bottoms.

Carefully tuck under the seam allowance of the RIGHT SIDE WAISTBAND and pin into place onto the bottoms. Use a short slip stitch to secure by hand.

With the bottoms WS out, pin and stitch the RIGHT SIDE FRONT and BACK garment crotch seam allowance.

With the garment still WS out, fold the WRONG SIDE BACK crotch seam allowance under and pin over the FRONT WS seam.

Secure using a short slip stitch.

Fold the NECK TIE in half. If you do not have a seam turner, place a length of string within and straight stitch in place at one end of the Tie. Change to zig zag stitch and stitch along the seam allowance. Once you get to the other end leave it open.

Gently pull the string and help guide the NECK TIE to turn RIGHT SIDES out.

Repeat for the BUST TIE.

Thread through the spaces in the TOP FRONT necklines and the BUST TIE CHANNELS.

Complete by using Fell Stitch by hand to secure the open crotch and Tie seam.