Beanbag Chair Tutorial

 

STEG 1:

Klipp ut alla bitar. Börja med att vika pilar i Top Bakst. Pin och stygn.

 

STEG 2:

Pin the Top Back onto the top of the Top Seat piece and stitch. Start pinning at the centre then the edges, lätta resten på plats.

 

STEG 3:

Pin and stitch the Center Front and Centre Top of the Side Panel pieces right sides together.

 

STEG 4:

Take the Top Seat and Top Back pieces that were previously joined and carefully pin them in place onto the Side Panel matching the centre point first then pinning around. Sy.

 

STEG 5:

Stift och sy Tillbaka till sidopanelen. Begin pinning from the Centre Top easing the rest around.

 

STEG 6:

Pin the Bottom piece to the Side Panel and Back pieces. Markera placeringen för zip. Börja sy i slutet av zip punkten säkra med en efterstygn. When you reach the start of the zip point secure with backstitch then change stitch size to large and sew the zip seam.

 

STEG 7:

Fold the ZIP ENDS in half and place across the zip end placements.

Nåla och sy zip bandet till sömsmånen mellan det markerade området av sidopanelen och bottenstyckena. Använd en zip fot att sy nära blixtlås. Se till att lämna zip öppna lite för att kunna få tillgång till de tillfälliga stygn.

 

STEG 8:

Noggrant unpick tillfälliga stygn och öppna upp zip. Tur bag höger sida ut och topp stygn runt blixtlåset på den högra sidan av tyget.

 

STEG 9:

Fold the remaining ZIP ENDS in half.

With the bag WRONG SIDES out, place the ZIP ENDS over the first ones already sewn in.

Pin and stitch through each ZIP END and the zip tape. Trim the excess from the sides.

 

STEG 10:

Upprepa alla tidigare steg för att skapa en inre påse för att hålla bönorna. I stället för att markera för en stor zip, mark for a small 20cm zip along the marked zip line where the side panel and bottom pieces join.

Sedan gå vidare och fyller upp din beanbag!

The outer cover is designed to be removed so you can wash it when needed, while the lining bag retains all the beans.

Filling the bags can be very tricky and messy. It may be easier to do if you use an old plastic bottle with the ends cut off as a funnel. Insert into the zip opening and close the zip up to it to hold in place. Then gently tip or scoop the beans in.