Valentina Jumpsuit Tutorial

Valentina Jumpsuit Tutorial

The Tailoress PDF Sewing Patterns - Valentina Jumpsuit Tutorial

The Tailoress PDF Sewing Patterns - Valentina Jumpsuit Tutorial

Hình ảnh có sẵn trong các mẫu tải về.

Cut out all pattern pieces and mark pleats. Use a jersey ballpoint needle throughout and a stretch stitch such as zig zag unless otherwise stated.

KHÔNG BẮT BUỘC: Finish the seam allowance along the necklines of the TOP pieces using zig-zag stitch or an overlocker

Arrange the pleats on the shoulder, pointing towards the center. Fold 2.5cm under along the neckline to form the facing. Sew a straight line of straight stitch across the shoulder from side to side to secure the pleats and facing.

Fold the ARMHOLE CUFF in half along its length. Match the raw edges to the armhole of the TOP. Ease it around.

Pin and stitch in place then finish the seam allowance either with zig zag stitch then trimming or using an overlocker.

Turn the TOP WRONG SIDES out.

Match the side seam allowances. Khâu và kết thúc trợ cấp đường may như trước.

Lặp lại các bước 1-3 for the other TOP section.

With the two TOP sections RIGHT SIDES out, match the waistlines together and pin in place.

Alternate which half of each TOP is visible on either side.

Fold the TROUSER CUFF in half along its length. Match the raw edges to the lower edge of the TROUSER. Dễ nó trên.

Pin and stitch in place then finish the seam allowance..

With the TROUSER WRONG SIDES out, fold the leg in half using the cowl seam marker as reference for the center.

Stitch and finish the seam allowance of the cowl.

With the TROUSER still WRONG SIDES out match the inside leg seam allowances.

Ghim, khâu và kết thúc.

Lặp lại các bước 5-7 for the other TROUSER.

Turn one TROUSER WRONG SIDES out. Place the other TROUSER inside and match the crotch seam allowances RIGHT SIDES together.

Ghim, khâu và kết thúc.

Lay the TROUSERS RIGHT SIDES out.

Fold the WAISTBAND in half along its length. Fold the end edges inside 1.5cm to hide them.

Pin the WAISTBAND around the TROUSERS matching the open ends with the centre front.

Stitch within the seam allowance.

Arrange the TOP sections RIGHT SIDES together with the TROUSERS and WAISTBAND. Match side seams.

Pin in place ensuring no seam allowances have been missed out.

Stitch và kết thúc phụ cấp đường may.

Create the WAIST TIE by following the STRAPS AND TIES TUTORIAL. Ensure to use zip zag stitch.

If you have a loop turner:
Fold the TIE in half lengthways and sew the seam allowance with zig-zag stitch. Rẽ bên phải bằng cách sử dụng một turner đường may.

Finish the TIE by tucking the raw ends inside and use small stitches to secure. Insert into the WAISTBAND to complete.

Download the Valentina Jumpsuit PDF Sewing Pattern here

cổ phiếu