步 1:
Suitable for fleece/jersey/towelling fabric
Turn the SLEEVE cuff back 1.5cm to the RIGHT SIDE, 然後再將其折回 3 厘米.
Top stitch close to the edge on the RIGHT SIDE.
步 2:
Match the back SLEEVE armhole with the BACK, 右側在一起.
引腳和線跡. Finish with either an overlocker or zig-zag stitch. 修剪縫份.
步 3:
Match the FRONT armhole with the front SLEEVE, 右側在一起.
銷, 縫合和前完成.
重複步驟 1-2 對於其他袖窿.
步 4:
與一起回來鋪設前右側, matching the side seam and SLEEVE seam allowances.
銷, 縫合並完成.
Clip almost up to the seam allowance at the underarm point to allow the garment to lay flat once turned. If you have finished the seam allowance close to the body this may not be necessary
步 5:
Finish the garment hemline using your preferred finishing method.
Turn the hemline towards the WRONG SIDE 1.5cm.
Topstitch to secure.
步 6:
Fold the length of the COLLAR in half RIGHT SIDES together.
Pin and stitch the two shorter ends. Clip the corners and trim down to 5mm.
打開右側出.
步 7:
Match the raw edges of the COLLAR around the garment opening.
銷, 縫合並完成.
Top stitch close to the seam from the RIGHT SIDE to secure the seam allowance flat.
步 8:
Lay the two WAISTBAND pieces RIGHT SIDES together.
Pin and stitch all around leaving a gap of approximately 10cm to turn right sides out.
Turn RIGHT SIDES out and press seams flat. Top stitch around the edges to hold flat and seal the 10cm opening.
Apply a piece of velcro to either side of the WAISTBAND at the ends, approximately 5cm long.
步 9:
Align the WAISTBAND with the underarm points.
Top stitch through the WAISTBAND and BACK to secure in place.