手帕高級教程

手帕高級教程

The Tailoress PDF Sewing Patterns - Handkerchief Top Tutorial

圖像在模式可供下載.

For this pattern to work you can use any length and width of fabric so long as it not any less than 1m x 1m. Using larger amounts will result in a longer top or dress.

Begin by finishing the lower edges of the FACING pieces and the edges of the main square of fabric (if it isn’t already finished), using a rolled hem or overlocking stitch.

Lay the two FACING pieces RIGHT SIDES together and pin and stitch the side seams.

 

Decide on which way you’d like the corners of the ‘handkerchief’ to fall. Cutting it open along the the straight of grain will have all the corners draping at the sides of the garment. Cutting it along the bias will have the corners hanging at the centre front and back and sides.

Mark the ARMHOLE and NECKLINE points.

把你的布片對折, 然後再半, creating either a square or triangle. 標記正確的測量有關褶皺面. Measurements shown represent distance from centre point.

Cut across the fabric from the centre point to the ARMHOLE and NECKLINE points, opening up the centre of the fabric.

 

SIZE Neckline Armhole
4 14cm 18cm
6 14cm 18cm
8 15cm 18cm
10 15.5cm 19cm
12 16cm 19cm
14 16.5 20厘米
16 17cm 20cm
18 17.5 20.5

Open up the cuts and lay the fabric out with the front and back necklines together.

Match the FACING with the necklines RIGHT SIDES TOGETHER, the side seams match with the low points of the underarm cuts. Insert the STRAPS to the front and back points, between the FACING and the handkerchief. Make sure to have the STRAPS RIGHT SIDES together with the handkerchief.

引腳和線跡.

When approaching the inward corners, sew down to the point, put the needle down then turn your work and ensure the fabric is flat without any wrinkles before continuing to sew.

Back stitch over the STRAP insertions to properly secure.

Clip the inward points almost to the stitch line, and trim the outer point to reduce bulk.

打開服裝右側出.

Gently press along the facing edge to set the seam.

Download the Handkerchief Top PDF Sewing Pattern here

分享